Linksys AM300 Quick Configuration
This User Guide provides step-by-step instructions on how to
configure a Linksys AM300 modem using the quick
configuration utility.
Why is this task performed?
This user guide will assist you in configuring the Linksys –
AM300 modem using the quick configuration utility.
Troubleshooting
If after completing this user guide you are unable to get online
a factory reset of the modem may be required. Please refer to
the Linksys AM300 user manual for instructions on how to
complete a factory reset.
What tools are used to complete the task?
Linksys AM300 Modem, Linksys AM300 User Manual,
Ethernet/USB cable and a PC.
Page 1 of 7
Linksys AM300 Quick Configuration
In the Log In screen, complete the
following steps:
In the Username field enter:
1
admin.
In the Password field enter:
2
admin.
1
2
3
Click
.
3
Page 3 of 7
Linksys AM300 Quick Configuration
In the Setup screen, complete the
following steps:
From the Encapsulation drop
1
down menu select RFC 2364
PPPoA.
Note: The page will refresh to
include the PPPoA section.
1
Ensure the VPI is set at 8 and the
VCI is set at 35 from the Virtual
Circuit ID: field.
2
2
3
4
Select the VC radio button from
the Multiplexing field.
3
4
5
From the DSL Modulation: field
select Auto.
5
6
Enter the username in the
Username field.
Refer to the Settings Page on our
website for the username format.
Enter the password in the
Password field.
6
Refer to the Settings Page on our
website for the password format.
Page 4 of 7
Linksys AM300 Quick Configuration
Scroll down the Setup screen,
complete the following steps:
From the Timezone drop down
1
menu select the time zone
applicable to the state you are in.
Click
.
2
1
2
Page 5 of 7
Linksys AM300 Quick Configuration
In the Settings are successful screen,
complete the following step:
Allow up to 25 seconds for the
1
previous page to load.
1
Page 6 of 7
Linksys AM300 Quick Configuration
In the Status screen, complete the
following steps:
1
Click on Status.
1
Ensure the PPP Login field is
2
displayed as Up.
This indicates the modem has
authenticated.
If the Up field hasn’t displayed
after a few minutes perform a
factory reset (Refer to manual)
and complete this userguide
again.
If this doesn’t resolve the issue
contact our Customer Care team.
You have completed the
Linksys AM300 Quick
Configuration Userguide and are
now ready to connect to the
internet.
2
Page 7 of 7
|
La Crosse Technology Portable Radio WS 7078TWC User Manual
LG Electronics Network Hardware N4B1 User Manual
Lightolier Work Light IS_CCM User Manual
Lincoln Automobile 2011 MKS User Manual
Line 6 Laptop Pilot Enhandbook User Manual
Manhattan Computer Products Power Supply 168212 User Manual
Marantz Stereo Receiver SR8400 User Manual
Metra Electronics Automobile Accessories 99 3100 User Manual
Metz Camcorder 34 AF 3N User Manual
Microsoft Computer Hardware IBUS BAT 1370 User Manual